Mircom Products Fire Detection/Input Devices FX-2000 Intelligent Modules CZ-6 Six Conventional Zone Interface Module

CZ-6 Six Conventional Zone Interface Module

CZ-6 Six Conventional Zone Interface Module
View Full Image


The CZ-6 Six Zone Interface module provides an interface between the intelligent alarm system and a two-wire conventional detection zone. A common SLC input is used for all modules, and the initiating device circuits share a common external supply. Otherwise, each module operates independently from the others. The first module is addressed from 01 to 94 while the remaining modules are assigned to the next five higher addresses. Provisions are included for disabling a maximum of two unused modules. All two-wire detectors being monitored must be two-wire compatibility listed with the modules. The CZ-6 transmits the status of a zone of two-wire detectors to the fire alarm control panel. Status conditions are reported as normal, open or alarm. The interface module supervises the zone of detectors and the connection of the external power supply.

UL


Specification

Order Information
CZ-6

Six Conventional Zone Interface Module
BB-2S
Module enclosure with built-in chassis; holds maximum of two modules
BB-6S
Module enclosure, chassis sold separately; holds maximum of six modules
CH-6S
Mounting chassis for BB-6 enclosure

Literature

500 Series Multiple Input And Output Modules

Sales

Canada

Tel: (888) 660-4655
Fax: (888) 660-4113
Email

USA

Tel: (888) 660-4655
Fax: (888) 660-4113
Email

International

Tel: +1(905) 660-4655
Fax: +1(905) 660-4113
Email

Support

An installation manual has not been published for this product. Please reference the product Data Sheet for guidance for general installation. For more information, please contact Mircom Technical Support.

Phone: 1-888-660-4655            E Mail: Click Here

Service Tools

Click Here
For complete listing of all Mircom Software/Firmware Updates

Click Here
For ESD Section

Click Here
If you forgot your password for ESD Section

Click Here
If you would like to apply for access to ESD Section or to apply for Training