Mircom

When using FH or FHS series signals with a SDM-240, what should the jumpers be set at?
I presume the high or low setting is a matter of choice, and the electromechanical or 3000Hz setting is also a matter of choice.

However, must the horn pattern be set at non-temporal? If so, can you direct me to the statement in the manual, as I haven't found it in either the SDM manual or the FHS manual.

The FH and FHS series have 3 selectable jumpers to select the tone pattern; the tone sound and the tone volume.

The tone pattern jumper is used to select the output pattern; the options are temporal tone (333) or Non-Temporal (steady).

The tone jumper is used to select the tone output; the options are Electoral Mechanical and 3000Hz.

The tone volume jumper is used to select the tone volume high or low.

The tone pattern is normally set for temporal code; however it is dependent on your local code.

As far as the tone selection and the tone volume, this is a matter of choice or the db sound level that is required in the application.

So, the horn will sound either temporal or non-temporal, depedning on the setting, regardless of whether it is connected to a synch module or not. Got it.